MicroLog will work with the following sensors:

Back to MicroLog FAQs

MicroLog displays readings of internal sensors and the external NTC temperature sensor. When working with any other external sensor you can display readings only by downloading the data to the software. The MicroLog display shows Et while taking measurements of these sensors.

Back to MicroLog FAQs

The MicroLog battery's maximum lifespan is approximately 1.5 years. If you use high sampling rates, the MicroLog battery's lifespan will be considerably shorter (see figure below):

Back to MicroLog FAQs

No, data can be downloaded either by cable communication or by wireless RF transmission

Back to MicroLog FAQs

Press the two MicroLog's button simultaneously for one second:

The MicroLog will display its status:

	Run MicroLog is recording data. It will stop recording automatically when its memory is full (16,000 recordings)
	Cyclic Run Same as Run, but MicroLog will record over the old data when the memory is full, beginning with the earliest data recording

Back to MicroLog FAQs

The MicroLog should be checked for calibration once a year. We recommend to send the MicroLog to a certified calibration laboratory or to return the MicroLog to fourtec for factory calibration

Back to MicroLog FAQs

The humidity calibration procedure updates both the MicroLog and the software. You will see correct readings both in MicroLog’s display and in the software.

The temperature calibration, however, will update the software only

Back to MicroLog FAQs

Repeat the calibration procedure. This time be careful not to touch the humidity sensor with your fingers when clicking the Default button

Back to MicroLog FAQs

The usable transmission range is 300m line of sight. physical obstacles like walls and buildings may reduce the range considerably.

You can use fourtec's RF repeater to double the usable range or to overcome line of sight problems. In this case place the repeater so it can "see" both the Cradle and the receiver

Back to MicroLog FAQs